TP-C812B - Measure lead

Main features

  • Connectors
    • Instrument side isolated female BNC connector
    • Test point side red and black 4 mm shrouded banana jacks
  • Bandwidth 7 MHz
  • Safety CAT III, 1000 V, double isolated
Price request Datasheet

The Measure lead TP-C812B is a low noise differential measure lead designed to be used with the Handyscope HS6 DIFF, Handyscope HS4 DIFF. This 2 meter long measure lead splits in two individual ends of each 1.2 meter long. The BNC connector at one end plugs directly on the instrument. The two other ends each feature a single 4 mm banana jack, on which application specific test points, clamps or probes can be plugged.

The Measure lead TP-C812B is very flexible, uses a heat resistant silicone isolation and shrouded banana jacks.

The specially designed Measure lead TP-C812B has a high Common Mode Rejection Ratio (CMRR), it is very insensitive to external interfering signals. The two ends can be placed up to more than two meters apart, while picking up very little interference. With a conventional oscilloscope with a standard oscilloscope probe this is not possible. The maximum distance between the positive side and ground is then usually limited to approximately 20 cm. And this 20 cm is very susceptible to interference. The Measure lead TP-C812B for the Handyscope HS6 DIFF, Handyscope HS4 DIFF and does not have this disadvantage. External interference is very well suppressed by the special construction of the Measure lead TP-C812B. Measuring between two distant points is now possible.

TP-C812BMeasure lead

ea71825e5dd543cef6d1e93fb7263b2cRRRRRRRRRRRRRRRRRRR